WARNINGA radio-controlled model is not a toy and is not intended for persons under 16 years old. Keepthis kit out of the reach of younger children, a
109. Insert the throttle tubing into the rear cableexit hole. Push the tubing into the fuselage while allow-ing the tubing to pass through the hole
11INSTALLING THE LANDING GEAR Collect the following items:(6) 10-32 x 1” Socket Head Bolts (4) #10 Washers(2) Landing Gear (left & right)(2) Lowe
4. Place the wheel pant over the axle. Install one wheel collar with set screw then thewheel, finally the second wheel collar with setscrew. Using
13 Gather the following items(1) fuel tank(1) rubber tank stopper(1) clunk (1) 3mm x 25mm screw(1) cap washer large(1) cap washer small(2) 3mm x 40mm
14INSTALLING THE ENGINE 1. Collect the following items:(2) Motor Mounts(1) Engine(4) #10 x 3/4” sheet metal screw(10) 8-32 x 1” Philip Head Screw(10
153. Keeping the engine perpendicular to the tabletop, clamp the other motor mount to theengine. Mark and drill the second motor mountthen screw the
167. Mount throttle servo in the servo tray.Note: Your installation may vary dependingon the engine used. Install pushrod connector on your servo
177. Remove the cowl and, with a moto tool, slow-ly remove the fiberglass INSIDE the cutoutoutline. Work slowly and carefully, until thecowl matche
18Remove3. Place the windshield onto the front of the fuse-lage. Using a pencil, mark where the windshieldover lap's the side of the fuselage
193. Starting with the front of the wing strut, attachthe bottom clevis to the lower strut bracket. Keep twisting the upper clevis till the strut f
2INTRODUCTIONUSING THIS INSTRUCTION MANUALBefore you begin assembling your Stinson ARF, takesome time to read through this entire instruction book. I
3ITEMS NEEDED TO COMPLETE THIS AIRCRAFT 1 RADIO GUIDANCE SYSTEM (6 CHANNELMINIMUM REQUIRED WITH 8 SERVOS) 2 12” AILERON SERVO EXTENSION WIRES 2 24
42. Locate the pre-cut aileron hinge slots and flapslots in both wing halves. Using a hobby knife(#11 blade), slide the blade into each slot tomake
5AILERON SERVO INSTALLATIONNote: The following pictures may not exactly matchthe hardware you are using. Always check the radiomanufacturer's in
62. With the aileron servo in place, make a markat a 90º degree angle to the trailing edge andin line with the servo arm.3. Position the control h
7TAIL CONSTRUCTION* Collect the following items(2) Right & left Stab(1) 10mm x 182mm front stabilizer tube(1) 10mm x 312mm Rear Stabilizer tube(2)
85. With the servo in place, remount both stabiliz-ers and make a mark at a 90º degree angle tothe elevator hinge line, and in line with theservo ar
Make a slot on the hinge line for the bracket.Make sure that the bracket and wire isbetween the fuselage and the rudder. 4. Install the hinges into
Comments to this Manuals